Jump to content
Evolv DNA Forum

Voku

Members
 View Profile  See their activity

  • Posts

    17

  • Joined

  • Last visited

    Never

 Content Type 

Posts posted by Voku

  1. Screen not working correctly. Mod still working fine?

    in Report a Bug

    Posted

    plcockrell said:

    I just received my Hana Modz DNA 200 today. I had been using it for about 3 hours when the screen went blank on me. The mod is still working normally but the screen is just blank. If I plug the device into my computer and then bring up the device monitor I can see it working. This happening completely randomly. I was using the mod, went to re-drip, and the screen just stopped working normally.

    When I try to restore the default settings, the screen will come on with the Upload Settings text so I know the screen is working. It will also come on with the Evolve DNA 200 logo when you reboot the device and when I tried to flash the firmware again. The only other time I can see the screen is when the device is locked it will flash the device locked screen quickly if I hit the power button.

    I have also tried putting the device into stealth mode and then turning it off. No luck.

    I have not been able to find anything else on this issue and I hope it is just firmware glitch. I am loving this chip to much to have to send it back already!

    Below is the device monitor screen shot.

    Capture2.png


    Edit: Also if I press capture screen it comes up blank as well. Which is making me think this could be a firmware issue?



    I have the same problem. :P



  10. Temperature Control not working at all.

    in Report a Bug

    Posted

    ACWalkerII said:

    I'm having a similar issue. Dual coil 10 wrap each, 3mm bit, 24g Ni200, set at 400 degrees and 80 Watts.

    Some times it works and works well. And then out of no where it stops working, I get the ---F no temp read out and it seems to be pushing straight power to the Ni200 coils. If I sit there and hold the fire button it will fire until the juice is all gone the coils go red hot and literally burst into flames.

    The last time this happen I decided to build new coils. These new coils id have set up nearly the same way. Instead of ---F Id get a reading of 2000+ degrees and then it would stop firing for being over temp. After a few times firing it the temp reading would then go back to ---F and start firing straight power to the Ni200 coils.

    Mod: Reuleaux DNA200
    Atti: CCI Archon
    Coil wire: Ni200 from Lightningvapes




    I had a similar problem , and after a while Wismec stopped working. Now it is out of warranty at the store.It seems to me that the issue of 510 there was no response from the atomizer + low backlight of lcd

  12. Wismec Reuleaux - Device won't start - Battery bay problem

    in General Discussion

    Posted

    If my other set didn't work at all i'd lower the deck for the positive but because my other set makes a connection i think it's just the bad efest  3000


    https://www.e-cigarette-forum.com/forum/threads/warning-efest-purple-35a-3000mah-is-now-a-10a-battery.720251/
    [CODE]https://youtu.be/vOLfAQovmGM[/CODE]

    Batteries only LG HG2 or Sony VTC5 :D
    Efast there is no specification of the battery is not a company that produces batteries

×
×
  • Create New...