esoj413

I downloaded a SS profile off lightning vapes. Been going low on the preheat and playing around with the settings, tuning things as needed for different builds. This thing is awesome. Such a great experience. You've all been very helpful. Thank you.

Yea this thing is great. It's doing fine on its own without me trying to adjust the settings. I'll tweak it as I learn. Can you recommend a build? I agree about the juice type factoring in cuz some gunk up more than others. And yea, I pulse at very low wattage. They usually turn a nice color blue.

I've never used anything other than SS. I like that you can dry burn it. It's also nice that it doesn't gunk up easily in tc mode, especially with spaced coils

Funny you mention that. My temperature started indicating 800 degrees and going into instant temp protect mode. I plugged it into the computer to check it out and noticed the ohm's readings were way out of whack. Checked the deck and sure enough a few of the screws were loose, tightened them down and no issues since.

Thanks, Black lace. I switched up the build, didn't mess with any settings other than making it temperature dominant. Didn't even lock the resistance and this thing is putting out dense flavorful clouds at 45 watts and 460 degrees. I have a lot to learn, and I'm looking forward to browsing these threads for more info. I'm just thankful I have no more dry hits and my 26650 has been goin hard since yesterday afternoon. Cheers.

Device: Hcigar vt75 Coil: SS316L 28 gauge 11 wrap around 2.5mm Raw Ohms- .569 Nominal Ohms- .564 (kanthal) .571 temp Room temp- 73.21 F I can't get a good vape unless I set the temp to over 500 degrees. On another device, I would get similar results at much lower settings. I set my watts to 30, preheat to 1, bad result. Watts to 30 preheat to 30, bad result. Adjust the resistance by a few increments, bad result. Rebuilt coil, cleaned all threads, adjusted cathode pin on mod, bad result. Mod resistance is set to 0, haven't gotten around to changing that, but if I'm adjusting the resistance of the build by a few increments to no avail, then would adjusting the resistance of the mod make that much of a difference? I love the features of the DNA chipset, the escribe software is refreshing after being with YIHI, and I love the consistency of the TC when it works right. Would anyone be willing to kindly explain how I can fine tune the settings so I may enjoy using TC with this device? Any advice is appreciated. Thanks. Oh, and then with the atomizer analyzer, I have the resistance set to lock in the main screen. Then I unlock resistance from the analyzer, but it still indicates locked despite uploading the settings, and then connecting and downloading the settings. -Joe