Dodecaphonix

Thanks for the help! Here are my terminal commands and responses. Commands were run 5-10 apart from each other. I've added "in:" "out:" for clarity, but actual terminal commands were X=READ BMS as instructed. What should I try next? in: X=READ BMS out: X=24 in: X=READ BMS out: X=24

I have two identical Lost Vape Project Sub-Ohm Triade DNA 250C devices. One of them is having charging issues. I've hooked the malfunctioning device up to the Device Monitor and here is what I've observed: it reads a consistent voltage from the usb power supply at about 10 second intervals it will read usb current and then quickly snap back to zero current I've designed a theme where I can monitor these values from the device UI and this behavior is seen on all chargers that I hook it to. Things that I've already attempted in order to resolve the issue: different sets of batteries high amperage USB chargers low amperage USB chargers updating firmware verify that identical, functioning device behaves properly in all above tests