inteks
-
Posts
8 -
Joined
-
Last visited
Never
Content Type
Profiles
Forums
Downloads
Posts posted by inteks
-
-
thx for explanation. with the right settings it works "nerarly" as expected
but i still think that power drops to early. could get a bit closer to configured temp!
in the srceens i use a dual nife48 coil 0.32mm 6 wraps 3mm 0.13Ohm
but the preheat is more importent with claptons....
-
Maybe thats the problem. 10F and 10C are not the same. If perheat stops at 10Celsius before temp its to low. I tryed with punch 11 but it still stops perheat to early.Wayneo said:...the preheat works until you're within 10F of your set temperature and then stops...
-
yes on 2. screen it looks like preheat is working. but why does it stop after a second if it doesnt reach the configured temp?
the wattage falls down at 200°C instead of 230°C ?!?! -
it is celsius 230°C more than enough
-
ok.
here are 3 screens with 10w 30w and 75w...
at 30w it looks like a "little" preheat. but its far away from configured 5sec. !
and it doenst reach the configured 230°C before it falls down...
-
no.no....i set this only for testing.
atm i use 50w 230° ignoring that the preheat is not working ... it's ok.
but i like to know why preheat not work.
ps: i will post a devicemonitor screen when i'm @ home -
hi,
on my hotcig dx75 the preheatfunktion doesnt work
to double check i made a profile with temp at 230° and 10w and 75w preheat for 5sec. and it stays cold. what is wrong?
thx
inteks
DNA75 Preheat doesnt work...
in General Discussion
Posted
thats an other prob i have with my dna. if i dont lock ohm and im vaping outside (its cold) the chip goes far too low with detected ohm value and i have to raise the temp up to 300°C (max) and it still not hot enough.
normally i let it cool down at room temp check resistens and lock it.