AGoyer001
-
Posts
12 -
Joined
-
Last visited
Never
Content Type
Profiles
Forums
Downloads
Posts posted by AGoyer001
-
-
literally very simple, took me maybe 5 minutes total
-
yes, I live in South Florida (they're based in Miami), it took a little over 2 weeks to get it back. I was having TC issues as well so they replaced the board and display
-
my VS started having screen problems about a month ago, had to send it in for repair
-
when using titanium wire, you can pulse it to clean but need to drop the watts down around 10 and do not let it glow bright, you are looking for a dark orange color.. I actually pulse in a dark place so I can see when the coils start to glow and back off
-
While I have not used this wire Steam engine does have it listed
http://www.steam-engine.org/coil.asp?mat=nife30 -
I use google chrome and escribe pulls it right in
-
And my vs 200 died this morning. 8/28/15 date
-
Vapor shark says their dna 200 won't support SS in tc mode based on their configuration of the mod
-
My vs 200 won't hold a warm vape.. I get 6-10 good hits then it goes to cold vape, I change to a different profile and it's good again.. Having to toggle back and forth is nuts though. I'm thinking its a bad unit
-
Same FW same tcr file from steam engine, had similar issue when using TI as well
-
I have an early vs dna 200 and an hcigar 200. The temp control is vastly different between them. UD bellus tank, dual Ss 316L coils .25 ohm. The vs I'm at 70 watts and 500 degrees F The hcigar 200 is at 60 watts/ 420 degrees The hcigar has a much better flavor and warmer vape yet running at a much lower temp.. Seems one of these units is not good ( I'm thinking it's the vs- vapor shark)?
What tanks/drippers on your DNA200?
in General Discussion
Posted
Aromamizer V2 and Aromamizer Supreme (top fill). great tanks, had the V1 before, used to like Bellus until I tried these