Handyman
-
Posts
7 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Posts posted by Handyman
-
-
My old HCigar VT133 mod shipped with what I believe were Evolv default case thermals. I was unable to run the thermal setup for some reason, but after changing these settings to what other users (here on this forum) determined were optimal, the vape performance was much better. Hoping that better manufacturers are providing the proper settings, not just slapping together a mod with the minimal effort required.
-
Are the case thermal settings set properly for the Paranormal Dna250c by the factory? Or are they the evolv defaults?
-
Thanks for the reply. I examined the battery sled and board for questionable solder connections, but all looked perfect. Interesting about the resistors.. I don't charge through the mod, and hadn't connected the mod to a computer in over a month.
I sent in a help desk ticket, and am waiting for a reply.
Meanwhile I'm back to using my VTC-Mini for a while. -
I had the same problem with my VT133 today. 0 volts on cell 1, 5.22v on cell 2.
Same exact behavior as olegasan shows in his video here.
This occurred randomly today. I haven't even connected the mod to Escribe in a couple of months, so it seems to have nothing to do with the service pack upgrade.
While troubleshooting, I connected the mod to Escribe and upgraded to sp5.2, but the problem persists. -
When I switched battery sets today, I see the HCigar VT133 logo for a split second when pressing the Fire button, then nothing. Mod not working. Holding the Fire button displays "Check Battery."
Batteries each measure 4.2v each in my charger, but Device Manager reports:
Cell1: 0 volts
Cell2: 5.22volts !!
(HG2 batteries)
I've cleaned the contacts, and tried the battery set that I just removed, with the same result (previous battery set was working fine earlier today).
Any suggestions as to what I can do to get the mod working again? Thanks!
250C software
in EScribe, Software and Firmware
Posted · Edited by Handyman
Where is this SP13 download located? I don’t see it on the DNA250C page and haven’t found it in the forums, other than your post.
Thanks for posting this, as after installing Escribe (INTL) from the DNA250C page, the DNA250C wasn’t listed on the opening screen. After installing this service pack, it is. I just want to keep an eye out for future versions. Thanks again.