[DNA 250 Help]

Ok - many thanks. I will give it a clean.

Thanks again

[DNA 250 Help]

Attached

[DNA 250 Help]

Do you need to see a screen shot for both attys?

[DNA 250 Help]

Ok, thanks. Out of interest why do the screen fields change on different atomisers??

[DNA 250 Help]

Hi, I need some help! I have a new DNA250 mod and have the SS316 profile set up. However, when I put my goon on it in temp mode it shows Volts but when I put my Kennedy on it in the same mode it shows Watts....?! Can I change this to show watts for both? I read somewhere I can do this from the mod but can't work it out. Pictures attached. Cheers.

[Temp protection]

Thanks again.

Slightly off topic, but if I were to use Kanthal A1 coils would the DNA board automatically adjust to Wattage/power mode or do I need to set up a separate preset? Assume I can still limit the heat the coil gets too?

Thanks

Mark

[Temp protection]

Many thanks for getting back to me. I have attached some files. Hope these help as im very new to DNA mods - usually use mechancials but wanted to use temp control.

Thanks.

Mark

[Temp protection]

Newbie help please!! SS Dual Fused Clapton build coming out at 0.19ohms. Vaping the Efusion SS316L preset but getting the Temp Protection message very quickly. Not getting much of a vape at all. Temp is set at 450F. Any suggestions as getting frustrated! Thanks Mark