lordbyron77
-
Posts
18 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Posts posted by lordbyron77
-
-
-
Hi, after many failed attempts I didn't found how to display the real time temperature of the coil on my 75C. Anyone can help me?
-
WOWOWOWOWOWOWOW!
-
Mine in Italian https://vimeo.com/user8560119/75
-
now it is clear we must consider the resistivity increases from early activation. I saw that you are proficient with Excel, are you able to develop a similar table to the above with Ni200?
-
ok, it is a variable that I had not considered
-
this is clear. what can I not explain is the graph. If you look at the attachment you will see that Ni200 limit seems lower than the Kanthal mode
-
-
ESCRIBE, part II Good evening, I'd like to understand better what was stated by Busardo from min 35, about TCR fails. Can gently someone expand Busardo's explanation? http://youtu.be/csOQTYEht5I
-
Good evening, I'd like to understand better what was stated by Busardo from min 35, about TCR fails. Can gently someone expand Busardo's explanation? http://youtu.be/csOQTYEht5I
-
John said:
Well, no, not unless you area having problems with the resistance readings shifting or climbing.
Really it is only pictures of devices having problems that are exciting to me. Last I hears Hana has done 450 of them, and as this thread isn't 450 posts long, my hope is that most are working swimmingly.
I can't take pictures because one of the fuor screws is too tight, and I can't unscrew it
-
I am puzzled by the timing of management problems.
Even considering the time zone, the timing of the one (useless) reply that I had, requested a working day and now I am still waiting for a permanent solution to my problem.
When I buy a product I buy also the assistance, and in this case I'm not getting in the right timeframe.
I hope to use a V200 fully functional in September -
We have the exact same problem my coils work perfectly on other devices, while the V200 gives me an error of several tenths of ohms in the first reading, and then everything works badly as a result. The error in the reading is the same, reading from AA or from V200
-
Hello, yesterday came my Hana Modz V200 and it worked properly for a few hours, then began mistakes in the reading of the resistance. I tried to update the firmware, making resets (hard+soft) and various atomizers all of them properly with DNA40. Is there a procedure to restore completly my mod?
Living in Italy, I would avoid Others postage and customs to require direct assistance froma Hana Modz.
I reported to Hana Modz my issue, but didn't get any reply
Early Firmware and EScribe Suite Discussion Thread
in EScribe, Software and Firmware
Posted
Everithing working fine 👍
Dry-cotton test at 200-220-240-260 Celsius, SS316L 0.4mm (Zivipf) 0,41ohm.
Small pic for attention 😀