[DNA 75 will not go to 'sleep' - Any ideas?]

My "mod never goes to sleep" problem was solved by Evolv, but they advise to contact SBody, as this is a daughterboard issue and they don't have C1D2 daughterboards on hand. I was lucky, they had one then and swapped it and the DNA completely.

R

[DNA 75 will not go to 'sleep' - Any ideas?]

dwcraig1 said:

Gee, maybe open a ticket with Evolv and link to your posts in this thread.
https://helpdesk.evolvapor.com/index.php?a=add&category=1

roger wilco

Thanks,
R

[DNA 75 will not go to 'sleep' - Any ideas?]

Nope, tried the default settings - same. If the brightness of charging is set anywhere above 0%, it'll go there and show the battery %.

It won't turn the screen off even when you select "Turn off screen after firing".

Tried helloimage fix again - same results: it works for ~15minutes, then lights up to the charging screen.

Also, the red light stays lit after unplugging the cable until the Fire button is pressed, but that was before then too. If you unplug the cable while there is no atty on the mod, you can't turn that red light off with no buttons. Attach an atty, press fire, then it goes away.

Tested soft reset, hard reset, latest firmware, newest firmware again - nuffin.

Any ideas? Should I report it in the Bugs section?

Thanks,
R

[DNA 75 will not go to 'sleep' - Any ideas?]

Earlier fix. 

R

[DNA 75 will not go to 'sleep' - Any ideas?]

Thanks. I'll see if that helps. The mod went back to that charging screen 15 min later..

R

[DNA 75 will not go to 'sleep' - Any ideas?]

helloimage said:

SOLVED!!!

Seemed to have been related to USB sync/signalling...

Process used to re-fresh screen change modes on a laptop PC:

1. After adjusting settings in escribe, upload settings to device
2. Press Disconnect button in escribe
3. With USB cable plugged in, close the screen (effectively sleeping the computer and ports)
4. Wait for the 'charge bolt' to go off
5. Disconnect USB from the mod (leave other end connected to laptop)
6. At this point, the mod acts as if it's in charge mode still (but no bolt)
7. Fire the mod once
8. Before it goes idle, PLUG the USB cable back into the device!
9. The charge screen goes away and all is good in the Evolv DNA75 world!

Thanks to those that helped...this was a weird one for sure.

Worked for me too. Thank you. 
But this is not the way it should be. Is there a way to reset a DNA75 board back to its bare and raw settings, to the settings before time and space?

Thanks.

R

[DNA 75 will not go to 'sleep' - Any ideas?]

Same issue as the OP has/had with the Vapedroid here. When I got mine, it was second-hand, set to factory settings and worked fine. Got the .cvf file from pbusardo's page to get that "droid" look. That's when it started. Going to read through, make adjustments and report.

R