Jump to content

Change in resistance value when heated


Recommended Posts

For some reason, when I press the button to heat it up, the resistance drops a little. Normally the resistance should go up when heated, right? After it goes down, it stabilizes, but why does the resistance go down a little only at the first heating? I'm using Kanthal wire.

And I use it in orthodox power mode.

Link to post
Share on other sites
59 minutes ago, vape vape said:

Hello! Thank you for yesterday!

Dry Fire is running properly. The other mods are stable, but only the billet box has a slight drop in resistance on the first firing.

Is this been with all coils that you have been using or is it just with this one?

Link to post
Share on other sites
11 hours ago, vape vape said:

when I press the button to heat it up, the resistance drops a little

How much is a little?

11 hours ago, vape vape said:

After it goes down, it stabilizes

Stabilizes at the higher value, or the lower value?

Post a screenshot like above while firing, showing that behavior 

  • Like 1
Link to post
Share on other sites
  • 2 weeks later...
On 5/28/2021 at 8:07 PM, Wayneo said:

How much is a little?

Stabilizes at the higher value, or the lower value?

Post a screenshot like above while firing, showing that behavior 

0.03 resistance drop and stabilizes at the low end Sorry it took me so long to get back to you, thanks.

 

Link to post
Share on other sites

A 0.03 drop is nothing to worry about at all, especially with a Kanthal coil in power mode. Surprised you could even see that on the screen, but next time if you're concerned, you can Post a screenshot like above while firing, showing that behavior  🙌

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...