jsforder

DNA250c Balance port info needed please

Recommended Posts

Hi all,

Im looking to build a mod using a 250c board and use a 2s lipo. Could someone please confirm the wiring for the balancer socket please?

The battery balancer jack has 3 pins, looking at the wiring diagrams Im assuming I connect the 3 pin socket starting at the GND pin, the middle socket pin goes to T1 and the right socket pin goes to T2, I then bridge GND to the negative pad on the board and also bridge T2, T3, T4 to the positive pad on the board?

Any help confirming this would be great before I blow myself up.

Thanks

Share this post


Link to post
Share on other sites

If  you are going to bridge gnd to B- and T2,3 and 4 to B+ then you only need the center wire from pack to T1.

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now