DNA 200 Fuse blown

Recommended Posts


I was using my dna and suddenly it simply stopped working, the fuse and board were fine. I decided to replace the board on Thursday which i did, 

The second board blew the fuse, after the fuse i can see a short to ground so i removed all the mosfets, then i removed the 1μH inductor (which is actually damaged) and then the diodes, and it's still it's SHORTED!!!

Anyone has an idea before i get my hammer and make it more compact? Is it the board? The second board had only a few days of light use (i don't actually use the full potential of the board) and there were no special conditions, it just popped the fuse while standing by. Any ideas are appreciated.

A few pics





  • Like 1

Share this post

Link to post
Share on other sites

Well..... I found it. replaced the two mosfets on the battery side and now it works fine as before.

Didn't even had to buy mosfets since i had the other 2 crap units.


Thank's for the huge support.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now