Jump to content

Up button "auto fires"

Recommended Posts

The up button on this new board automatically increases the power until it goes off.  The button seems to work as it should and as the down button.  This happens without the exterior button in place.  Is there any cause for this other than the button being defective?  Thanks.

Link to post
Share on other sites

Have you taken the button apart, cleaned or look at the insides, then put it back together?

The light green actuator is held in place by the outer metal frame.

You can lift it (metal tab only) slowly by one edge, and it'll come off at like a 45 degree angle, then just lift the rubber part up. Check and clean, put it back together.

  • Like 1
Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...