tehdarkaura

battery analysis failed insufficient samples

Recommended Posts

So i get this message when I try to test my battery -- I am using two 1 ohm 100 watt resistors in parallel 

not sure what the issue is -- any advice would be appreciated.

I am using a laptop and a longish usb cable... not sure if that could contribute to this sort of issue.

Capture.jpg 

Share this post


Link to post
Share on other sites

Hi,

I got a new squonk mod with DNA75C, same issue whatever the usb cable used.

EScribe version 2.0 SP 15.1 INT

Firmware 1.1 SP 33 INT

if someone knows how to perform a battery analysis, could he share how to proceed ?

Regards

Edited by Niet

Share this post


Link to post
Share on other sites

I had the same issue, it was resolved by;

1, plug mod into e-scribe,

2, turn mod on (while plugged in)

3, measure resistance of the test atomiser (also while plugged in)

worked fine for me after that.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now