Search the Community
Showing results for tags 'vtbox'.
Found 5 results
-
Hello, I've connected the box to Escribe, updated the firmware and then run the Case Analyzer. During every cooldown round the AMPs to the box were not 0. It fluctuates around 0 by some mAMP towards the positive side. This lead the temperature to raise and stabilize around 6/7 °C over the room temp. This seems to invalidate the Analysis as during the cooldown the box should be left free to cooldown towards room temp. Using the monitor and disabling USB recharge in Diagnostic allow the 0 AMP on USB and the box drift to the room temperature properly. Some details on setup: VTBOX 250c Escribe last stable (tried on linux and windows on two differente laptops) Used different USB cables
-
-
Version 1.0.1
439 downloads
VTbox250C original theme official Update the theme for "replay" -
Hello ! My screen replacement just arrived, but I honestly have no idea where to begin and I can't find any guide online pertaining specifically to VTBox 250 by VapeCige. The screen is the large replacement you can order from evolvapor itself (https://www.evolvapor.com/products/dna250) Does anybody have any related experience or can guide me in the right direction? Thanks!
-
Hi, I'm new on the forum and I have just receveid a vtbox DNA 250 after my dear wismec 2/3. I'm also new with escribe, but after a lot of videos I'm now a bit pratical of it and I want to ask you if you can give me some advices of settings. I use the ss316l and kantal a1, what are your advices? Can you attach an image of your configuration? Also with other type of wire, thanks.
