Search the Community

Check battery issue keeps coming up, i don't think its the batteries i have multiple sets and have tried a bunch of different types. Brand new device will not read an atomizer but is making contact with 510. Any time i try to fire it says check battery, and the battery percentage reads %4 no matter what batteries i put into the thing. I have tried pretty much all the normal stuff like setting it to default, hard reset, updating software. I have used, mixed, and new married batteries none will work properly. I have opened the mod up and looked on the inside and nothing looks dodgy, the soldering looks decent. Pic is device monitor picture with 3 batteries married same type in (LG).

I have this problem with my dna 75,someone know it,I must change display or the chip? the fire works like a dna75! WhatsApp Video 2018-04-06 at 23.47.33.mp4 WhatsApp Video 2018-04-06 at 23.49.59.mp4

I just picked up a LV DNA75c Paranormal mod and have it paired with a gold Druga RDA, with a dual transformer .15 ohm build @ 70w. This morning, I was attempting to use the device 4 days owning it, no problems before at this point. I came across a strange issue, when Everytime I went to fire the mod, I would get "Temperature Protection" error Everytime zi attempted to fire. Even when mod was cold. I had the mod reread the coil build and noticed it was all over the place, read it once it reported .28, then .34, the .38, back down to .21 just all over the place. I had thought that one of my leads had come off, essentially making the dual build single @ .3 ohms. After further inspection of coils, and putting mod on ohm meter, it was still a very solid .15. perplexed, I looked at the mod & noticed some juice down in 510 pin area, since I drip. I cleaned it thouroughly, as well as bottom of RDA and threads. Now, 2hrs later, I have yet to see this error. I wanted to point this out if any of you Drippers out there get any juice run down into the 510 pin area, be sure to clean it out. This might save someone the hassle like I had of trying to troubleshoot, thinking it's a much bigger problem. Have a good one, it's a frigid 14° F here in Ohio today, keep it cloudy friends!

I recently got the Hcigar VT250S and every time I change to two batteries it gives me the check battery error. I went to Escribe and changed the settings to Two Cell at 160 watts and it did nothing. Please Help!

hey all. I'm hoping someone has some insight as to why my mod is misbehaving. Ive been using my spiffy new vtinbox for about four days. ive messed with some themes and steam engine csv.'s but I'm still fairly new to the DNA community. So- I took a few puffs this morning and then swapped batteries. With the new fully charged bat I was about to take a few more pulls before getting my kids breakfast. unfortunately the mod wont turn on. I tried several different fully charged bats as well as the dead bat i'd hit earlier. Now, I can get it to turn on when its connected to usb but when I hit the fire button it shuts down and shows the welcome screen again. When in device monitoring (not firing) I see the voltage readout jump between 4.2 and 3.8V. does anyone have any suggestions?