Search the Community
Showing results for tags 'case analyzer'.
Found 3 results
-
Hello, I've connected the box to Escribe, updated the firmware and then run the Case Analyzer. During every cooldown round the AMPs to the box were not 0. It fluctuates around 0 by some mAMP towards the positive side. This lead the temperature to raise and stabilize around 6/7 °C over the room temp. This seems to invalidate the Analysis as during the cooldown the box should be left free to cooldown towards room temp. Using the monitor and disabling USB recharge in Diagnostic allow the 0 AMP on USB and the box drift to the room temperature properly. Some details on setup: VTBOX 250c Escribe last stable (tried on linux and windows on two differente laptops) Used different USB cables
-
Triade dna250c, case analyzer, device still charging at 0.001- 0.009 amps when i run case analyzer its showing my mod still charging at 0.001- 0.009amps.the battery is at 25% an left sitting for a few hours before running the test.i have tried a firmware update, soft and hard reboots, disabling usb charging. i have checked the battery profile, its ok.i have NEW (LG HG2 batteries)LINK to batteries https://cdn.shopify.com/s/files/1/0674/3651/files/lg-hg2-spec-sheet.pdfI have looked online for hours for a fix but no fix, just other people with the same problem. But there is no information on how they resolved the issue.can you please help me fix thisthanks I have lodged a ticket and so far there has been no help this is the reply I got. (Your battery needs to be fully charged before starting the test. Additionally, I would let the device sit for and hour or so before starting the test) I don't think anyone actually read my ticket!
-
