Search the Community
Showing results for tags '3 cell'.
so about a week ago my lipo started charging properly on my DNA 200 board, now i know that i have had this for awhile (just over 1 year) but it went from charging 1amp to .31 and .019 when plugged into the wall and my computer. i did get 100% charge on an RC car charger but the dna no longer charges to 100% unless i wait about a day for it to finish (took 8 hours to get to 30%.) the lipo pack is not expanding and it is rated at 2200mah at 50c so it should not be a battery issue (no expansion on the pack either.) i have tried soft and hard reset and even a firmware install from escribe, setting up the battery profile and everything. if there is any advice that you may be able to give i would greatly appreciate it.