-
Posts
22 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Posts posted by jakeT
-
-
9 hours ago, etab75 said:
Select a graphic in TD, and up will pop Load/Save/Actions... choose save
Thanks! I still can't see it though. I'm using the Mac beta perhaps that is why. The closest I can get is to double click an image/gauge and it will open a finder window, but it's a seemingly irrelevant window.
-
2 minutes ago, etab75 said:
start off with saving a few images from other themes and see how they are composed.
How do you do this?! I’ve been trying to figure this out for days now lol
-
At 25W you'll get about 850 seconds total run time. Divide that by the average time of your puffs to find how many puffs you should be getting out of it.
E.g. my puffs are around 3.5 seconds long, 850/3.5 = 242. If I were using it I'd expect to get somewhere around 240 puffs out of a full charge.
Hope that helps!(This is assuming that the nominal voltage of the battery is 3.7v and an efficiency of 90%)
- 1
-
Escribe beta for Mac: https://forum.evolvapor.com/topic/68861-mac-escribe-beta-thread/
-
3 minutes ago, Sherif_Moris said:
I wonder why DJLSB mentioned in his review that it is 0.0081? I don't have a clue
I was wondering this also. Does the internal resistance vary between mods of the same model?
-
I’ve noticed something with watt increments but it could be just me.. new to evolv and escribe.
On default condition my increment is set to 1 and no decimal places so it changes 61, 62, 63 etc. I added a condition so if the wattage is equal to or less than 20 it will display 1 decimal place and change in increments of 5. If I start above 20 Watts and try to lower it, it goes 21, 20, 19.0, 18.0 etc. It will only start adjusting by .5 if I unselect and reselect after going below 20 Watts.
On the way up it works ok - 18.0, 19.0, 20.0, 20, 21 etc.
- 1
Boost Question
in General Discussion
Posted
I believe you have to change Max Output under the Mod tab, at least that's what worked for me!