Jump to content

UKDTweak

Members
  • Posts

    117
  • Joined

  • Last visited

  • Days Won

    9

Posts posted by UKDTweak

  1. I find the 510 threads are a tiny bit rough once my atty gets close to the bottom and be careful of scratching the top as the 510 is flush, battery life is good, @55w on a dual twisted TI coil setup i can get around 320 puffs, my dual 18650 DNA200 will do around 400 with the same, but the let down is recharge time is horrible with the lipo.... 

  2. Nick said:

    [QUOTE=UKDTweak]I give you, the Lost Vape Efusion:



    Where are they in stock at? Would like to grab a few.

    Also, here is the ammo can power supply.

    http://www.mouser.com/ProductDetail/Cosel/PBA1500F-12/?qs=sGAEpiMZZMsPs3th5F8koMdmNRcX8UdIkKh46IJzk6xYI%2ff6%2fXG47A%3d%3d[/QUOTE]

    I got mine from Vapegeek.co.uk, only the silver and black in stock at the time which was yesterday morning.
  3. Just got my DX200, Updated the firmware to the latest via Escribe, the device Monitor show each cell around 1.74v and the pack at around 4.7v, plugging it into a USB charger from my Samsung Mobile and I have the charge display set to show amps being used and its showing 000A, does not appear to be charging, so i have plugged in the supplied charger to see if an hour or so on it will bring the battery to charge...

  4. Ive not had any issues with mine in dual 18650... device monitor shows the Cell Pack correctly and the two other cells, but cell 3 always shows a random low voltage, as for cell cut off, I set mine to 3.2v and low an behold, when I started to get the Weak Battery message I ran the device monitor and could see both Cells at 3.5v, but when I took a puff it dropped to 3.2v... so spot on I thought?

    With regard to reverse battery protection, Evolv said there is none when using dual 18650 and that is why they will be releasing an add in board just for that, though like I said, ive put mine in wrong twice and the chip is still working a week later...

  5. Ive put my batteries in wrong twice now, the second time i did not notice straight away, one battery got rather hot and the second got warm, i just pulled them and left it to cool. The first time there were no ill effects, the second time when the batteries got hot... the device was a bit flaky for a while, would not power up or would come on and go straight off, but after leaving the batteries out for an hour... its been working as normal since.

  6. I have been using a Lemo 2 on TC for months now with Ni200 and about 3 weeks on Titanium, even got a second one a few weeks ago, only time ive had a bad hit is when the ohms have been off due to selecting new coil when I should have said old, though my second Lemo 2 was rather jumpy at first on the DNA200 until I reversed the 510 pin in the base, now its spot on.

×
×
  • Create New...